Now serving:Chandigarh · Mohali · Panchkula · Zirakpur · Ahmedabad · Dehradun · Delhi · Faridkot · Gurugram · Indore · Ludhiana · Mumbai · Noida · PuneGet ₹100 off on total service charges above ₹3,000Call now: +91 92708 07381

Microwave & OTG Repair in Bishanpura, Zirakpur

Visiting charge ₹150 · the cost of the work is told after the technician has seen itSame day · Pay after service

Solo, grill and convection microwaves and OTGs repaired at home where they can be, and in the workshop where they cannot. Anything carrying a magnetron is handled by someone trained for it.

Book now
Microwave & OTG Repair in Bishanpura, Zirakpur

Microwave in Bishanpura

Bishanpura is the old village that became Sector 8 of Zirakpur's municipal area, with the police station and Chandigarh Enclave in it, Kishanpura and Nagla Road beside it and Paras Downtown Square a kilometre and a half off — village houses and the plotted colonies and society blocks that grew around them, small kitchens on each rented floor, and geysers on hard borewell water.

A microwave on a rented floor in Bishanpura often shares one socket with the kettle or an induction plate, because the floor was never wired for many kitchen appliances. A plug that runs warm or a supply that dips can blow the oven's fuse or stress its control board. A dead display after a click, or buttons that answer only some of the time, are the signs. The technician checks the fuse and thermal cut-out, then the door switches that often take the fuse with them, then the keypad and PCB, and tells you the cost before replacing anything.

We cover Bishanpura as part of Zirakpur for microwave & otg repair, with the same technicians as the rest of the city — the visit itself is ₹150. The technician tells you the cost at your door, after he has seen the fault and before he starts, and you pay after the work.

Common faults

Runs but does not heat

Price after checking45 to 90 minutes


  • Fuse, diode, capacitor and magnetron tested in order of cost
  • The cheapest cause is checked first, not last

Sparking inside

Price after checkingAbout an hour


  • Usually a burnt waveguide cover
  • Stop using it until this is put right

Turntable not turning

Price after checkingAbout 30 minutes

Buttons or display not working

Price after checking45 to 90 minutes

Door not closing or the latch broken

Price after checkingAbout an hour


  • A microwave with a faulty door interlock should not be run at all

Loud fan or a burning smell

Price after checkingAbout an hour

OTG not heating or heating unevenly

Price after checkingAbout an hour


  • Elements, thermostat and timer checked

Parts replaced

Magnetron replacement

Price after checking1 to 2 hours

High voltage capacitor or diode

Price after checkingAbout an hour

Fuse or thermal cut-out

Price after checkingAbout 30 minutes

Turntable motor or coupler

Price after checkingAbout 30 minutes

Door switch or latch assembly

Price after checkingAbout an hour

PCB or membrane keypad

Price after checkingDepends on the part

OTG heating element

Price after checkingAbout an hour

How it works

1Pick the jobAdd what your microwave needs from the list, or just tell us what is wrong; the cost is told once the technician has seen it.
2Leave your numberWe call back to fix a time. No advance, no payment on the site.
3The technician comesAt your door in Zirakpur, with the tools and the usual parts. The amount is confirmed before work starts.
4Pay after the workCash or UPI once the job is done and checked. A bill on request.

Microwave brands we service in Zirakpur

We service LG, Samsung, IFB, Whirlpool, Godrej, Panasonic, Bajaj, Morphy Richards, Philips, Bosch and Haier — genuine parts where the brand still supplies them, quality equivalents where it does not, and we tell you which before fitting.

Microwave & OTG Repair across Zirakpur

HouseTech Care covers Zirakpur, Punjab for Microwave & OTG Repair. We work across VIP Road, Dhakoli, Peer Muchalla, Baltana, Lohgarh and 11 more localities. Most jobs fall within about 14 km of VIP Road, so a same-day slot is usually possible.

Microwave & OTG Repair starts at ₹349 here — the same rate we charge across the tricity. The technician confirms the final amount at your door, including the cost of any spare part, before starting. There is nothing to pay in advance.

Zirakpur is the tightest of the four tricity areas we work in — nine localities inside about fourteen kilometres, from VIP Road and Dhakoli through Peer Muchalla, Baltana and Lohgarh to Patiala Road, Singhpura and Nabha Sahib. The groundwater is hard here like the rest of the tricity, so the geyser and the RO are the two appliances scale reaches first. Alongside those we do chimneys, gas stoves and hobs, and gas pipelines, and send electricians, plumbers, carpenters, cleaners and pest control. Same-day slots are usually available. The amount is agreed before the work starts, and there is nothing to pay in advance.

Outside Zirakpur we also cover Chandigarh, Mohali, Panchkula for the same work.

What our microwave & OTG repair in Bishanpura, Zirakpur covers

  • Runs but does not heat
  • Sparking inside
  • Turntable not turning
  • Buttons or display not working
  • Door not closing or the latch broken
  • Loud fan or a burning smell
  • OTG not heating or heating unevenly
  • Magnetron replacement
  • High voltage capacitor or diode
  • Fuse or thermal cut-out
  • Turntable motor or coupler
  • Door switch or latch assembly
  • PCB or membrane keypad
  • OTG heating element

What Microwave & OTG Repair costs in Zirakpur

1Visiting charge ₹150Charged for every visit — the technician coming to you and finding what is wrong. It is separate from the cost of the work.
2He tells you the cost before he startsOnce he has seen it, the technician tells you the full amount — his work and any part.
3Nothing is done without your yesIf you decide not to go ahead, you pay only the visiting charge.
4You pay after the workNothing in advance, and you get a bill for what was done.

Microwave & OTG Repair in Zirakpur — frequently asked questions

That is the magnetron circuit: the fuse, the high voltage diode, the capacitor or the magnetron itself. They are tested in order of cost, so you are not sold the dearest part first.

Stop using it and unplug it. Sparking is usually a burnt waveguide cover, which is a small part, but running it that way damages the cavity, and then the repair is not small.

Most faults, yes. A magnetron or a board sometimes needs the workshop. You are told before it leaves the house, and it comes back tested.

For a solo microwave past eight or nine years with a dead magnetron, often not, and we will say so. For a convection oven or an OTG it usually is.

Yes. Elements, thermostats, timers and the fan on convection models.

No. The latch is what stops it running with the door open. It is an inexpensive part and should be done before the microwave is used again.

It depends on what is wrong, and that cannot be known before the technician has looked. He finds the fault and tells you the full cost — his work and any part — before he starts, and nothing is done without your yes. The visiting charge is ₹150 a visit and is separate from the cost of the work. You pay after the job.

We service LG, Samsung, IFB, Whirlpool, Godrej, Panasonic, Bajaj, Morphy Richards, Philips, Bosch and Haier. If your brand is not listed, call — most models share parts with one that is, and we will tell you honestly whether we can help.

Yes. We work across VIP Road, Dhakoli, Peer Muchalla, Baltana, Lohgarh, Bhabat, Patiala Road, Singhpura, Nabha Sahib, Bishanpura, Kishanpura, Gazipur, Dyalpura, Nagla, Airport Road, Dera Bassi. Anywhere within roughly 14 km of VIP Road is a normal same-day call. If your locality is not on that list, call and we will tell you honestly whether we can reach you the same day.

Yes. Bishanpura is inside our Zirakpur coverage, with the usual ₹150 visit charge. Call or WhatsApp with your address and we will tell you the earliest slot.

More often it is the main fuse, and a fuse usually blows because a door switch or the high-voltage side has failed. The technician tests those before fitting a new fuse, so it does not blow again, and looks at the board only if they are sound.
Call nowWhatsApp